To reduce the noise of receiving front-ends,the design and fabrication of an ultra-wide band Low Noise Amplifier(LNA),were presented based on negative feedback and wide band matching technologies. The amplifier tube ATF-54143 made by Avago was chosen for this design,whose key indexes were simulated and optimized by using ADS2009. The test results indicate that the gain is greater than 24 dB;the flatness is lower than ±2 dB over the four octaves 0.2 GHz-3.2 GHz. Noise Figure(NF) is below 1.2 dB over 0.2 GHz-2 GHz;and less than 1.5 dB over 2 GHz-2.6 GHz;less than 2 dB over 2.6 GHz-3.2 GHz. The good performance of this amplifier satisfies the requirement of engineering application,and it can be applied to the receiver front-end of communication systems.